Every furnace call starts with a combustion and carbon monoxide safety check, not just a symptom fix.
Flat-rate pricing quoted after diagnosis, no pressure toward a premature system replacement.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
Every truck across Green, OR carries the tools and common parts specific to furnace repair, so most calls finish in a single visit.

Cracked heat exchangers get flagged immediately as a safety issue, not just a repair line item.
We carry manufacturer service manuals for major furnace brands.
Diagnosis happens first, and the quoted flat rate reflects the actual confirmed fault.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
Every job starts with a real diagnosis, not a guess — here's the full scope of what our furnace repair technicians handle across Green, OR.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
Faulty gas valves are treated as a safety-critical repair, prioritized accordingly. Techs handling gas valve diagnostics carry the specific parts and tools this job calls for, not a generic kit.
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. This is one of the most requested furnace repair calls we get across Green, OR.
A furnace that runs but never blows warm air often traces to a blower motor or limit switch fault. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
Blocked or improperly sloped venting can back-draft combustion gases into the home. This is one of the most requested furnace repair calls we get across Green, OR.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
We confirm your Green address and a realistic arrival window.
Safety check first — combustion and carbon monoxide — then full mechanical diagnostics.
Most ignition and control repairs finish same-visit.

Furnace kept clicking like it wanted to light and never catching.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Thermocouple was the culprit, replaced and tested before the tech left.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
Could be a delayed ignition fault, a failed gas valve, or a limit switch issue — a full diagnostic narrows it down.
Electric resistance furnaces fail differently than gas units, and we diagnose accordingly.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
Call dispatch for a live arrival estimate based on current demand.

Whether you're in the heart of Green or one of the surrounding communities, dispatch routes the closest available technician.
☎ Call +1-866-805-8548 for Green Service